Measurement Procedures; Memory Functions - Nissei DS-1873 Instructions

MEASUREMENT PROCEDURES

Take deep breaths and relax.
Do not move, chat or strain your arm or hand
during measurement.
1
Insert TUBE PLUG
2 Press ON/OFF BUTTON
Inflation mark " " flashes and the monitor starts automatic inflation.
Inflation stops and pressure starts to descend.
The pulse is indicated by heart mark "
Maximum and minimum blood pressures
and pulse rate are displayed.
Deflation mark " " appears and the unit automatically exhausts the
air from the cuff.
Press either MEMORY BUTTON M1
3
M2 .
4
The displayed memory bank number changes as the button is pressed.
The result is stored in the selected bank.
The result is stored in the bank which is selected when the unit is
turned off. When a measurement resulted in an error, it will not be
stored.
4 Press ON/OFF BUTTON to turn off the power.
If you forget to turn off the unit, it will be automatically turned off
after 3 minutes.

MEMORY FUNCTIONS

Measured result is automatically stored in either M1 or M2. Make sure which memory bank number is displayed before turning off the unit.
Each of two memory banks can store up to 30 results and their average. When the number of measurements exceeds 30, the oldest data
will be deleted to record new data. You may decide which bank to store your measurement results to avoid data mixture with someone
else's, or may use two banks to save data measured in the morning and evening separately.
Recalling measured data
1 Press MEMORY BUTTON M1
into AIR CONNECTOR
11
.
2
".
or M2
3
Stopping Measurement
Press ON/OFF BUTTON
monitor will stop inflation, discharge
air rapidly, and then turn off.
.
5
Automatic Repressurization
If the pressure applied is judged insufficient in the early
phase of measurement or if movement of arm or hand
occurs during measurement, the unit will inflate again to
a level about 40 mmHg higher. Automatic Repressurization
is repeated until a measurement is made. However, this
does not indicate a problem.
To manually control pressurization, hold down ON/OFF
BUTTON immediately after the start of inflation and release
it when the pressure reaches the level 50 mmHg higher
or
3
than the expected maximum systolic pressure. If the
pressure value has exceeded 180 mmHg, the inflation
will stop when the key is released. Pressure can be
increased to approximately 300 mmHg.
Do not
measurements for congestion of
blood
measurement. Let your arm rest for
at least 5 minutes.
to see stored data.
4
- 12 -
see fig.4
2
excute
could result
see fig.5
page 5
and the
repeated
in false
page 6