Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 4.0
4.
Do not abuse the cord. Never use the cord to carry the tools or pull the plug from an
outlet. Keep the cord away from heat, oil, sharp edges or moving parts. Damaged
cords should be replaced immediately by qualified repair personnel. Damaged cords
will increase the risk of electric shock.
5.
When operating a power tool outside, use an outdoor heavy duty extension cord and
use in conjunction with a residual current device (RCD).
6.
If operating a power tool in a damp location is unavoidable, use a residual current
device (RCD) protected supply. Use of an RCD reduces the risk of electric shock.
7.
Recommendation for the use of a residual current device with a rated residual current
of 30 mA or less.
PERSONAL SAFETY
1.
Stay alert, watch what you are doing and use common sense when operating a power
tool. Do not use the tool while tired or under the influence of drugs, alcohol, or
medication. A moment of inattention while operating power tools may result in serious
personal injury.
2.
Dress properly. Do not wear loose clothes or jewellery. Contain long hair. Keep your
hair, clothes, and gloves away from moving parts.
3.
Avoid accidental starting. Be sure switch is off before plugging in. Carrying tools with your
finger on the switch or plugging in tools that have the switch on may invite accidents.
4.
Remove adjusting keys or wrenches before turning the tool on. A wrench or a key that
is left attached to a rotating part of the tool may result in personal injury.
5.
Do not overreach. Keep proper footing and balance at all times. Proper footing and
balance enable better control of the tool in unexpected situations.
6.
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your
hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair
can be caught in moving parts.
7.
Use safety equipments. Always wear eye protection. Dust mask, non-skid safety
shoes, hard hat, or hearing protection must be used for appropriate conditions.
Ordinary eye or sun glasses are NOT suitable for eye protection.
TOOL USE AND CARE
1.
Use clamps or other practical way to secure and support the work piece to a stable
platform. Holding the work piece by hand or against your body is unstable and may
lead to loss of control.
2.
Do not force the tool. Use the correct tool for your application. The correct tool will do
the job better and safer at the rate for which it is designed.
3.
Do not use the tool if the switch cannot be turned on or off. Any tool that cannot be
controlled with the switch is dangerous and must be repaired before use.
4.
Disconnect the plug from the power source before making any adjustment, changing
accessories, or storing the tool. Such preventive safety measures can reduce the risk
of starting the tool accidentally.
5.
Store idle tools out of reach of children or other untrained persons. Tools are
dangerous in the hands of untrained users.
4
5 in. Angle Grinder
For technical questions call 1-800-665-8685
8535023
Publicité
Table des Matières
