Double Insulation; Important Safety Instructions; Work Area; Personal Safety - Power Fist 8069643 Manuel Du Propriétaire

Rated Voltage: 120V~
Rated Frequency: 60Hz
Rated current: 8A
No loaded speed: 1,1000 RPM
Grinding disc: 125 mm

DOUBLE INSULATION

importAnt sAfety instructions

warnInG! read and understand all instructions. Keep this manual for the safety warnings
and precautions, operating, inspection and maintenance instructions. when using this tool,
basic precautions should always be followed, including the following.

wOrK area

1. Keep your work area clean and well lit. Cluttered and dark areas invite accidents.
2. Operate in a safe work environment. Do not use machines or power tools in damp or wet locations.
Do not expose to rain. Do not use power tools in the presence of flammable gases or liquids.
3. Keep children, bystanders and visitors away from the work area. Do not let them handle tools or
extension cords. No one should be in the work area if they are not wearing suitable protective equipment.
4. store unused equipment. When not in use, tools must be stored in a dry location to prevent rust.
Always lock up tools and keep them out of reach of children.

PersOnal safety

1. use eye, face and ear protection. Always wear ANSI approved impact safety goggles. Wear a full face
shield if your work creates metal filings. Wear an ANSI approved dust mask or respirator when working
around metal. Wear ANSI approved earplugs.
2. Do not over reach; keep proper footing and balance at all times. Proper footing and balance enables
better control of the tool in unexpected situations.
3. Dress properly, wear protective equipment. Do not wear loose clothing or jewelry as they can be
caught in moving parts. Tie back long hair. Protective, electrically non-conductive clothes and non-skid
footwear are recommended when working.
4. stay alert, watch what you are doing and use your common sense. Do not operate any machine or
tool when you are tired, under the influence of drugs, alcohol or medication.
5. use clamps or other practical ways to secure and support the work piece to a stable platform.
Holding the work piece by hand or against your body is unstable and may lead to loss of control.
tOOl use anD care
1. use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a
larger industrial tool. The tool will perform better and safer at the task for which it was intended. Do not
modify this tool or use for a purpose for which it was not designed.
2. maintain tools with care. Keep tools clean, sharp and in good condition for a better and safer
performance. Follow instructions for lubricating and changing accessories. Inspect tool fittings,
allignment and hoses periodically and, if damaged, have them repaired by an authorized technician
or replaced. The handles must be kept clean, dry and free from oil and grease at all times. A properly
maintained tool reduces the risk of binding and is easier to control.
For any technical questions, please call 1-800-665-8685
Angle
Grinder
2
8069643