Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8535023
MOUNTING AND ADJUSTING THE WHEEL GUARD
This tool comes with a wheel guard. The guard must be fitted before using the tool.
1.
Loosen the screw on the collar of wheel guard with a screwdriver.
2.
Align the protruding part inside the circular collar with the notch on the front cap.
Mount the collar fully onto the front cap.
3.
Turn the wheel guard to a desired angle after the collar is fully inserted. Retighten the
screw to secure the wheel guard.
OPERATION
This angle grinder is designed for the following purposes:
1.
Removal of casting burrs and finishing on various types of steel, bronze, aluminum
materials and castings.
2.
Beveling and finishing weld seams.
3.
Grinding of welded sections cut by means of welding.
4.
Grinding of synthetic resin bricks, marbles etc.
5.
Cutting thin wall tubes and small size metal materials.
CAUTION: Never cover air vents. They must always be open for proper motor cooling.
TO START YOUR GRINDER
1.
Plug the cord set into a power socket;
2.
Depress the lock-off button and pull on the trigger switch.
TO STOP YOUR GRINDER
1.
Release the trigger switch.
FOR PROPER OPERATIONS
1.
Before starting the grinder, put on safety glasses and make sure that the grinding
wheel, guard and the tool are in good condition and correctly fitted.
2.
Always hold the tool firmly with one hand on the rear handle and the other on the
side handle.
3.
Turn the angle grinder on and then apply the grinding wheel to the workpiece.
4.
In general, keep the edge of the wheel at an angle of about 30° for roughing and about
15° for finishing.
5.
Move the grinder back and forth or up and down over the work area.
6.
Use just enough pressure to keep the grinder from chattering or bouncing.
7.
Avoid overloading the tool for a long time, heavy pressure will decrease its speed and
put a strain on the motor.
8.
Lift the grinder away from the workpiece before turning your grinder off.
WARNING: Never use your grinder without wearing eye protection. Following this rule will
reduce the risk of serious personal injury.
DANGER!
1. Never attach a wood cutting or carving blade of any type to this angle grinder.
2. Never use your grinder with guard removed.
3. Failure to follow this rule could result in serious personal injury.
Visit www.princessauto.com for more information
5 in. Angle Grinder
V 4.0
7
Publicité
Table des Matières
