Maintenance And Cleaning; Technical Data - Renkforce 1339075 Mode D'emploi

Maintenance and cleaning

• The product does not require maintenance except for occasional cleaning.
• Under no circumstances should you service any of the components in the interior of
the device, therefore never open it.
• Before cleaning, remove the XLR connector from the connected audio device.
• Use a soft, antistatic and lint-free cloth to clean the device. Dust can be easily
removed using a soft and clean long-haired brush.
• Never use aggressive and abrasive detergents, rubbing alcohol or other chemical
solutions, as these could damage the casing or even impair the functioning of the
product.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the
relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of the
environment.

Technical data

Operating voltage................................9 - 52 V/DC
Frequency response ...........................30 Hz - 20 000 Hz
Sensitivity .............................................-54 dB ±3 dB (0 dB=1 V/µbar at 1000 Hz open)
Impedance ...........................................250 Ω +30% (at 1000 Hz)
Directivity .............................................Hypercardioid
Working principle ................................Electret condenser microphone
Connection ...........................................XLR (3-pole)
Cable length .........................................3.1 m (without connector)
Operating conditions ..........................-20 to +60 °C, 45 - 85 % RH
Storage conditions..............................-25 to +70 °C, 45 - 85 % RH
Dimensions (Ø x H)..............................8 mm (Microphone head) x 260 mm
Weight ...................................................370 g
Frequency response
dB
Directivity
Hz
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE. V1_0615_02-DS