Care And Cleaning; Technical Data - Renkforce 2373339 Mode D'emploi

c) Operation
• The microphone only works with devices that provide enough power (i.e., input voltage of
DC 5 V, 100 mA).
• The microphone can be used alone when connected to a computer or mobile device with
OTG support.
• If the microphone is covered by your hand or is placed near loudspeakers, interference may
occur. To stop interference, decrease the volume and move the microphone as far away as
possible from the loudspeaker, making sure it is not pointed at the loudspeaker.
• The microphone is highly sensitive and so should not be dropped or subjected to strong
impacts.
• To maintain the sensitivity and quality of sound recordings and reproduction, do not expose
the microphone to moisture and extreme temperatures.

Care and cleaning

• Disconnect the product from the mains before cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol, or other chemical solutions as
they can cause damage to the housing and functioning of the product.
• Clean the product with a dry, fibre-free cloth.
Disposal
Electronic devices are recyclable waste and must not be disposed of in household
waste. At the end of its service life, dispose of the product in accordance with
applicable regulatory guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the environment.

Technical data

Input voltage ................................. 5 V/DC, 100 mA
Current consumption .................... 3 mA
Characteristics .............................. Unidirectional
Frequency response ..................... 20 – 20,000 Hz
Sensitivity ..................................... -32±2 dB (0 dB = 1 V/Pa at 1 kHz)
Output impedance ........................ 680 Ω ±30% (at 1 kHz)
Load impedance ........................... ≥1000 Ω
Equivalent max. SPL .................... 120 dB (at 1 kHz ≤1% T.H, D)
S/N ratio ........................................ 60 dB
System requirements .................... Windows XP or later
Mac OS 10 or later
Operating/storage conditions ........ -20 °C to 50 °C
20% to 80% RH (non-condensing)
Dimensions ................................... Microphone: 47 x 155 mm (Φ x L)
Case: 288 x 224 x 80 mm (D x W x H)
Weight .......................................... Microphone: 222 g
Case: 120 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2021 by Conrad Electronic SE. *2373339_V3_1221_02_jh_m_4L_(1)