Installing The Handle; Extension Cord - Fagor WC-46 DZ Manuel D'instructions

This appliance requires a standard 115/120 Volt AC
~ 60Hz three-prong grounded electrical outlet. Have
the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly
grounded. When a standard 2-prong wall outlet is
encountered, it is your responsibility and obligation
to have it replaced with a properly grounded 3-prong
wall outlet.
To prevent accidental injury, the cord should be
secured behind the appliance and not left exposed
or dangling.
The appliance should always be plugged into its
own individual electrical outlet that has a voltage
rating that matches the rating label on the appliance.
This provides the best performance and also
prevents overloading house wiring circuits that could
cause a fire hazard from overheating. Never unplug
the appliance by pulling on the power cord. Always
grip the plug firmly and pull straight out from the
outlet. Immediately repair or replace all power cords
that have become frayed or otherwise damaged. Do
not use a cord that shows cracks or abrasion
damage along its length or at either end. When
moving the appliance, be careful not to damage the
power cord.
THIS APPLIANCE MUST BE
EARTHED.

EXTENSION CORD

Because of potential safety hazards under certain
conditions, it is strongly recommended that you do
not use an extension cord with this appliance.
However, if you must use an extension cord it is
absolutely necessary that it be a UL/CUL-Listed, 3-
wire grounding type appliance extension cord
having a grounding type plug and outlet and that the
electrical rating of the cord be 115 volts and at least
10 amps.

INSTALLING THE HANDLE

IMPORTANT: Do not over tighten the screws and do
not use power tools to install the handle.
○
Place the handle 1 over the fixing pins
door and, using the supplied Allen key, tighten the
○
securing grub screws 2 to secure the handle.
REVERSING THE DOOR HINGE
It is possible to reverse the door on this appliance, if
required.
To do so, follow the steps below:
Note: All parts removed must be
saved to do the reinstallation of door.
1. Remove the front ventilation grille
adjustable ventilation grille
○ ○
the screws . (Fig. 1)
3 & 4
2. Remove the bottom
unscrewing the four lock screws
to hold the glass door firmly after removing the
screws. (Fig. 2)
7
○
3 of the
○ and the
2
○
by unscrewing
1
hinge plate ○ by
5
○
. Make sure
6