Troubleshooting Guide - Fagor WC-46 DZ Manuel D'instructions

PROBLEMS WITH YOUR APPLIANCE
You can solve many common problems easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before calling customer service.

TROUBLESHOOTING GUIDE

PROBLEM
1. Appliance is not connected to a power supply.
Appliance does not 2. The appliance is turned off.
operate. 3. The circuit breaker tripped or blew fuse.
1. The temperature is not set correctly.
2. The ambient temperature could require an
adjusted temperature setting.
3. The door was opened too often or held open for
too long.
Appliance is not cold
4. The door was not closed completely.
enough.
5. Door is not sealed tight enough.
6. The condenser is too dirty.
7. The ventilation opening is blocked or too dusty.
1. The room temperature is higher than average.
2. A large amount of bottles has been added to
the unit.
Appliance turns itself
on and off frequently. 3. The door is opened too often.
4. The door is not closed completely.
5. The door gasket does not seal properly.
1. Appliance is not connected to a power supply.
The light does not 2. The circuit breaker tripped or blew a fuse.
work.
3. The light was switched off on the control panel.
1. The appliance is not properly leveled.
Vibrations.
The rattling noise may come from the flow of the refrigerant, which is normal. As each cycle
ends, you may hear gurgling sounds caused by the flow of refrigerant in your appliance.
The appliance seems
If temperature fluctuations occur, the contraction and expansion of the inner walls may
to make too much
cause popping and cracking noises.
noise.
1. The appliance is not properly level.
1. The appliance is not properly leveled.
2. The door was reversed and not properly
installed.
The door will not
close properly.
3. The gasket is dirty.
4. The shelves are out of position.
1. "E1" or "E2" indicates that the air temperature
Display shows "E1".
sensor is failed.
"E2" or "E7".
2. E7" indicates the door switch failure.
POSSIBLE CAUSE
14
REMEDY
1. Connect the appliance.
2. Switch on the appliance.
3. Switch on circuit breaker or
replace fuse.
1. Check the set temperature.
2. Set a higher temperature.
3. Do not open the door more than
necessary.
4. Close door properly.
5. Check that the door seal is
clean and replace if necessary.
6. Clean the condenser when
necessary.
7. Clear the obstructions and clean
the dust.
1. Put the appliance in a cooler
place.
2. Leave the appliance untouched
for a while until the set
temperature has been reached.
3. Do not open the door more often
than necessary.
4. Close door properly.
5. Check that the door seal is
clean and replace if necessary.
1. Connect the appliance.
2. Switch on circuit breaker or
replace fuse.
3. Switch on the light.
1. Level the appliance with the
adjustable feet.
1. Level the appliance with the
adjustable feet.
1. Level the appliance with the
adjustable feet.
2. Check the door hinge and
reassemble correctly (See
Reversing the Door Hinge
section on page 7).
3. Clean the door gasket.
4.
Check the shelves and
reposition correctly.
Call for service.