Operating Your Appliance - Fagor WC-46 DZ Manuel D'instructions

3. Gently pull down to remove the glass door from
the right top hinge and place it on a padded
surface to avoid the risk of damage. Then
○
remove the right top hinge
7
4. Unscrew and transfer the hinge pin of the
○
bottom hinge plate to the opposite side.
5
5. Pop out the cover caps on the left side of
cabinet and use them to cover the screw holes
on the right hand side.
6. Screw the alternative left top hinge
in the fittings, on the left hand side of cabinet.
(Fig. 4)
7. Rotate the door 180° and then relocate the door
to the designated position. Then screw the
bottom hinge assembly on the left designated
position and tighten it after the door is leveled.
(Fig. 2)
8. Reassembly the ventilation grilles.
ATTENTION!

Only store wine in unopened bottles. Always lay
bottles on their side for storage.

Do not overload the cabinet.

Do not open the door unless necessary.

Do not cover shelves with aluminum foil or any
other material which may prevent air circulation.

Should the wine cooler be left empty for a long
period of time, we recommend you unplug the
appliance and after careful cleaning, leave the
door ajar to allow air to circulate inside the
cabinet in order to prevent possible
condensation, mold or odors from forming.
OPERATING YOUR
APPLIANCE
. (Fig. 3 & 4)
Active Charcoal Filter
○
, included
9
The unit should be placed in a position where the
ambient temperature is between 60ºF and 95ºF
(16°C and 35°C). If the ambient temperature is
above or below this range, the performance of the
unit may be affected. For example, placing your unit
in extreme cold or hot conditions may cause interior
temperatures to fluctuate and the temperature range
may not be reached.
Note:


8
Handle
Digital Control
Panel
Full Shelves (5)
Door
Ventilation
Grille
Adjustable
Legs
When you use the unit for the first time
or restart the unit after having been shut
off for a long time, there could be a few
degrees variance between the
temperature you select and the one
indicated on the LED readout. This is
normal and it is due to the length of the
activation time. Once the unit is running
for a few hours everything will be back
to normal.
If the unit is unplugged, has lost power,
or has been turned off, you must wait 3
to 5 minutes before restarting the unit. If
you attempt to restart before this time
delay, the unit will not start.