Adjusting The Temperature - Fagor VT-12 BIZONE Manuel D'utilisation

Technical Assistance Service for it to be
replaced.
• Do not leave the appliance exposed to
the elements (rain, sun, ice, etc.).
• Do not use or let any part of the
appliance come into contact or near
hot surfaces (kitchen gas or electric
hobs or ovens).
• Do not use detergents or abrasive
sponges to clean the appliance.
• Do not let the cable come into contact
with the hot parts of the appliance.
• When installing the appliance, make
sure that there is at least 5 cm of free
space at the sides and 10 cm at the
rear of the appliance. This will allow for
the appropriate amount of ventilation.
• Do not place hot food or drinks in the
wine cooler until they have cooled
down to room temperature.
• Close the door properly and do not
open it too often or for a long period
of time, as the wine will not reach the
selected temperature.
• Keep the appliance well away from any
heat source or direct sunlight.
• Do not place anything on top of the
appliance.
• Do not use the appliance outside or in
humid conditions.
• Keep the cable well away from hot
surfaces.
4. OPERATING INSTRUCTIONS
1. Place the wine cooler on an even,
horizontal and stable surface, well away
from hot surfaces and humidity.
2. Open the door (7) and place the shelves
(8) onto the guides inside the wine
cooler. Close the door (7).
3. Plug the wine cooler into a power socket
and select the desired temperature (see
"Adjusting the temperature" section).
4. Leave the wine cooler empty and in
operation for approximately two hours
for it to reach the temperature selected.
5. Once the wine cooler has reached the
selected temperature, open the door
(7) and place the bottles of wine at
room temperature on to the shelves (8).
The bottles will reach the temperature
selected in approximately 6 hours. This
time may vary depending on the number
of bottles put in and their temperature.
The wine cooler will automatically set an
on-and-off cycle in order to constantly
maintain the selected temperature.
Press the light button (6) to turn on the light
inside and see what there is in the top zone
of the wine cooler. Press the same button
again to switch off the light.
Important: Close the door (7) properly and
do not open it too often or for a long period
of time, as the wine will not reach the
selected temperature.

5. ADJUSTING THE TEMPERATURE

Select the top/bottom temperature for
the wine cooler by pressing button 1. The
temperature will flash, you can now change
it. Press the "▲" button (3) to increase the
temperature and press the "▼" button (4)
to reduce it. To change the temperature in
the other top/bottom zone press button
1 again. Finally, the temperature will be
confirmed when you stop pressing the
buttons (the temperature will stop flashing).
NOTE: The screen will always show the
temperature inside the wine cooler, so
immediately after increasing/reducing the
temperature, the screen will show the
temperature inside the wine cooler; two
hours later the wine cooler will reach the
temperature selected earlier and this will be
shown on the screen.
The temperature in the top zone has a
range of 12-18ºC.
The temperature in the bottom zone has a
range of 8-18ºC.
The unit's cooling system works efficiently
with an ambient temperature of 25ºC or
less.
Advice and recommendations:
• The recommended temperature for red
wine is 14-16ºC
• The recommended temperature for
white wine is 10-12ºC.
10