Crosley CR1704A-WM Manuel D'utilisation page 10

Jukebox Troubleshooting
No Power
• Ensure jukebox is plugged in to wall socket correctly.
• Verify the LED is glowing green on the AC adapter attached to the jukebox and
wall socket.
• Ensure wall socket is working properly and not switched off.
• Ensure AC adapter has all connections tight from the wall socket to the jukebox.
• Remove the AC adapter from the back of jukebox and plug back and ensure the
rear POWER switch is ON.
No Sound
• Check that the volume is turned up by pressing VOL+ button on the remote or front
control panel. NOTE: Volume range on some units start at level 1 and ends at
level 30 MAX.
• Make sure the SPEAKER INT.EXT.MIX. Slide switch on back panel of the jukebox
is switched to the correct setting. INT for internal speakers only, EXT for external
speakers only, MIX for both internal and external speaker operation.
• Check to make sure POWER switch is turned on and jukebox is receiving power
from the wall socket. Ensure POWER switch on back on jukebox is switched to
ON.
• If jukebox is operated in "AUX" input mode, ensure the device has a volume switch
which is adjusted properly.
CD does not play
• Ensure CD is inserted correctly, with label of CD facing up.
• Check to see that the surface of the CD is clean.
• Make sure the function switch is set to CD mode, with jukebox volume adjusted
properly.
• If CD was not commercially produced, it may be an unsupported format if produced
from a CD burner with audio files from a computer.
Remote is not working
• Replace batteries in remote.
• Be sure to point the remote towards the remote sensor when operating. Remote
sensor is located near center of jukebox, just above the "CROSLEY" name.
• Remove obstacles in the path of the remote and jukebox so the remote signal has
a straight path to the sensor that is on the front of the jukebox.
10