Crosley CR1704A-WM Manuel D'utilisation page 9

Platter Auto-stop
If the Auto-stop Switch is set to ON position, the platter will stop spinning
automatically when the record plays to the end. In some rare occasion, if the turntable
stops playing before the end of the record, set the switch to OFF position the turntable
should overcome this issue.
Needle Replacement (CROSLEY NP6)
Removing Needle
1. Gently pull down the front edge of the needle.
2. Pull needle forward.
3. Pull out and remove.
Installing Needle
1. Position the needle with its tip facing down.
2. Line up the back of the needle with the cartridge.
3. Insert the needle with its front end at a downward angle and gently lift the front of
the needle upward until it snaps into place.
Audio Controls – External Speaker Option
The jukebox does not require the use of external speakers. If you intend to fill a large
room or would like a larger volume, external speakers can be used either alone or in
conjunction with the speakers built-in to the jukebox. If you elect not to use external
speakers, be sure the SPEAKER switch is switched to INT. (Internal)
The speaker jacks for external speakers are located on the rear of the jukebox.
Located near the speaker jacks is a switch labeled INT (Internal Speakers Only) EXT
(External Speakers Only) and MIX. (Using both Internal and External Speakers) When
using external speakers only, this switch must be switched to the EXT position. Doing
this turns off the internal speakers in the jukebox and redirects the sound to the
external speakers only. The MIX position will play through both the internal jukebox
speakers and external speakers at the same time and will produce the highest volume
sound available. The MIX position will result in lower volumes through the internal
jukebox speaker if no speakers are attached and jukebox is operated in MIX mode.
9