First Time Installation - Sharp HT-SBW182 Manuel De L'utilisateur

6

First time installation

Placement and Mounting
A
A: Normal Placement
(Place Soundbar on leveled surface in front of TV.)
B: Wall Mounting
Wall Mounting
NOTE:
– Installation must be carried out by qualifi ed personnel only. Incorrect
assembly can result in severe personal injury and property damage (if
you intend to install this product yourself, you must check for installa-
tions such as electrical wiring and plumbing that may be buried inside
the wall). It is the installer's responsibility to verify that the wall will safely
support the total load of the unit and wall brackets.
– Additional tools (not included) are required for the installation.
– Do not overtighten screws.
– Keep this instruction manual for future reference.
– Use an electronic stud fi nder to check the wall type before drilling and
mounting.
1
560 mm
2
(4mm)
560 mm
1. Drill 2 parallel holes (Ø 6 mm) in the wall. The distance between the
holes should be 560 mm.
– Firmly fi x one dowel into each hole in the wall and then insert screws
into them.
2. Leave a 4mm gap between the wall and the screw's head. Lift the unit
with the attached wall brackets over the heads of the screws and slot
into place.
B
Connections
HDMI output (ARC)
The ARC (Audio Return Channel) function allows you to send audio
from your ARC- compliant TV to your sound bar through a single HDMI
connection. To enjoy the ARC function, please ensure your TV is both
HDMI-CEC and ARC compliant and set up accordingly. When correctly set
up, you can use your TV remote control to adjust the volume output (VOL
+/- and MUTE) of the sound bar.
– Connect the HDMI cable (not included) from unit's HDMI OUT (ARC)
socket to the HDMI (ARC) socket on your ARC compliant TV. Then press
the remote control to select HDMI ARC.
TIPS:
• Your TV must support the HDMI-CEC and ARC function. HDMI-CEC and
ARC must be set to On.
• The setting method of HDMI-CEC and ARC may diff er depending on
the TV. For details about ARC function, please refer to your TV owner's
manual.
• Only HDMI cables of version 1.4 or higher can support the ARC function.
• While in HDMI/ARC/OPTICAL mode, if there's no sound output from the
unit, you may need to activate PCM signal output on your source device
(eg. TV, DVD or Blu-ray player).
OPTICAL input
• Use the optical cable to connect the optical input of this soundbar to the
optical output of VCD, CD, VCR, DVD player.
TIPS:
• While in HDMI/ARC/OPTICAL mode, if there's no sound output from the
unit, you may need to activate PCM signal output on your source device
(eg. TV, DVD or Blu-ray player).