Belkin TuneSync F5U255ea Manuel De L'utilisateur page 12

Installation
Mac Users
IMPORTANT NOTE: Please do not connect any USB devices
to the hub until instructed to do so in step 3 of this
installation procedure.
1. Plug the AC adapter into a wall outlet or surge protector. Plug the DC
2. Plug the flat end (USB A connector) of the provided USB device cable
3. Attach a USB 2.0 or 1.1 device to the hub and begin using it.
Note: The hub must be connected to a USB 2.0-compliant host in order to
EN
Installation
F5U255ea.indb 6
connector into the DC power jack found on the rear of the hub.
into the downstream port of your computer or downstream port
of another hub. Then plug the square end (USB B connector) of the
device cable into the upstream port on the rear of the hub.
function in Hi-Speed USB 2.0 mode (480Mbps data rate). If the hub is
connected to a USB 1.1-compliant host, it will operate only in low- and
full-speed mode (1.5Mbps/12Mbps).
6
11/8/2005 10:06:41 AM