Description Of The Parts; Using The Machine - Clatronic HSM 2659 NE Mode D'emploi & Garantie

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

1. Adjustment of the cutting length

2. On/off switch

3. Lower blade

4. Upper blade

5. Blade rail

6. Voltage adjustment

(for mains operated machines)

Fine Adjustment of the Voltage (Mains operated Machines)

In the case of voltage fluctuations in the mains it may be necessary to adjust the

machine.

Switch on the device. Adjust the voltage tuning screw (6) with a screwdriver or a

coin until it starts to work as smoothly as possible.

Cutting with Cutting Length Accessory

1. Briefly comb the hair.

2. Remove the blade protection.

3. Slightly oil the blades.

4. Mount the cutting length tool necessary for the desired hair length. If you are not

certain which length to use, begin with 12 mm.

Push the blades into the recess and press the top on to the blade rail.

5. Insert the plug into a socket, switch the machine on and comb the hair "the

wrong way" slowly and at an even speed with the guide comb. The guide rail

should lie flat.

Cutting without Cutting Length Accessory

This is suitable for trimming the hair. The cutting length can be adjusted continuous-

ly in the range of approximately 0 - 12 mm.

For areas which are not accessible to the razor it is possible to use the scissors.

IMPORTANT: Do not use the device for more than 10 minutes. Before using it

again allow it to cool down for 10 minutes.

•

Disconnect the machine from the mains.

•

Clean the device after use with a dry cloth. Then wipe off again with a dry cloth.

•

The blades and accessories should be cleaned with the brush.