Before Getting Started - Franklin Electric INLINE 400 Manuel Du Propriétaire

Masquer les pouces Voir aussi pour INLINE 400:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BEFORE GETTING STARTED

Read and follow safety instructions. Refer to product data plate(s) for additional operating instructions and specifications.
This is the safety alert symbol. When you see this
be alert to the potential for personal injury:
s
DANGER
!
s
WARNING
!
s
CAUTION
!
s
NOTICE
!
indicates special instructions which are important but not related to hazards. Carefully read and follow all safety
instructions in this manual and on pump.
s
WARNING
!
RISK OF ELECTRIC SHOCK - This product is supplied with a grounding conductor and/or grounding-type attachment plug. To reduce the risk
of electrical shock, be certain that it is connected to a properly grounded grounding-type receptacle. Disconnect power before working on or
around the product.
This equipment should be installed by technically qualified personnel. Failure to install it in compliance with national and local electrical
and plumbing codes and within Franklin Electric recommendations may result in electrical shock or fire hazard, unsatisfactory performance,
or equipment failure. Installation information is available through pump manufacturers and distributors, or directly from Franklin Electric
at our toll-free number 1-800-701-7894.
This equipment must not be used by children or persons with reduced physical, sensory or mental abilities, or lacking in experience
and expertise, unless supervised or instructed. Children may not use the equipment, nor may they play with the equipment or in the
immediate vicinity.
If the power cord is damaged, it must only be replaced by qualified personnel.
s
CAUTION
!
• Keep work area clean, well-lit, and uncluttered.
• Keep safety labels clean and in good condition.
• Wear safety glasses while installing or performing maintenance on pump.
• Do not run pump dry. Fill pump with water before starting or pump will be damaged.
• Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. Wire pump system for correct voltages. Follow all pump wiring
instructions provided in the "System Wiring Diagram" and "Electrical Connections" sections of this manual.
s
!
symbol on your pump or in this manual, look for one of the following signal words and
warns about hazards that will cause serious personal injury, death or major property damage if ignored.
warns about hazards that can cause serious personal injury, death or major property damage if ignored.
warns about hazards that will or can cause minor personal injury or major property damage if ignored.
W A R N I N G
W A R N I N G

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

92061501920615039206150292061504

Table des Matières