Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe Vivenis 80 75010 Serie Mode D'emploi / Instructions De Montage

Safety Notes

Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal
pressures.

Installation Instructions

• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• The drain valve must only be used as intended. It is
not allowed to attach other objects to the drain
valve, for example a semi-pedestal.
• 75200XXX: If the instantaneous water heater
causes problems or if you wish to increase the water
flow, the EcoSmart
aerator can be removed.

Technical Data

This mixer series-produced with EcoSmart
(flow limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
Hot water temperature:
Thermal disinfection:
The product is exclusively designed for drinking water!
4
(flow limiter) located behind the
®
max. 1 MPa
0,1 - 0,5 MPa
(1 MPa = 10 bar = 147 PSI)
70°C / 4 min
Assembly (see page 33)
English

Symbol description

To adjust the hot water limiter. Using a hot water limiter
in combination with a continuous flow water heater is
not recommended.
Special accessories (order as an extra)
• Hansgrohe recommends not to use as drinking water
®
the first half liter of water drawn in the morning or
after a prolonged period of non-use.
• After periods of prolonged non-use, but at least
1,6 MPa
every third day, the fittings must be opened with the
handle in hot and cold position to prevent stagnation
max. 60°C
in the connecting lines. Let the water run until the
water temperature is constant.
Do not use silicone containing acetic acid!
Adjustment (see page 36)
Dimensions (see page 38)
Flow diagram (see page 39)
Spare parts (see page 40)
XXX = Farbcodierung
000 = Chrom
670 = Mattschwarz
700 = Mattweiß
• special tool #58085000 (see page 33)
• Installation putty (see page 34)
Cleaning (see page 41)
Operation (see page 37)
Test certificate (see page 44)