Required Tools; Accessories - Danby DAC150EB2WDB Manuel Du Propriétaire

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION INSTRUCTIONS
LOCATION
This air conditioner is designed for easy installation
in single or double hung windows. Since window
designs vary, it may be necessary to make some
modifi cations for safe installation.
This air conditioner is not designed for vertical,
slider type windows or "through the wall"
installation.
Ensure that the window and frame are structurally
sound and free from dry or rotted wood.
Install the air conditioner in a window on a side
of the building which favors more shade than
sunlight. If the appliance must be in direct sunlight,
it is advisable to provide a shade awning over the
appliance to ensure effi cient functioning.
Do not install the appliance where leakage of
combustible gas is suspected.
This appliance is designed to evaporate
condensation under normal conditions. Under
extremely hot or humid conditions, excess
condensation may overfl ow to the outside. The
appliance should be installed where condensation
cannot drip on pedestrians or neighboring
properties.
Provide suffi cient clearance around the appliance
to allow ample air circulation. The rear of the
appliance should be outdoors, it should not be in
a garage or another room. Keep the appliance
away from obstacles and at least 76 cm (30 inches)
above the ground. Ensure that curtains and other
obstructions do not block air fl ow to the appliance.
50.8 cm
(20 inches)
12 cm
(30.5 in)
50.8 cm
76.2 cm
(20 inches)
(30 inches)

REQUIRED TOOLS

• Screwdrivers: Phillips and fl at head.
• Power Drill: 1/8" (3.2mm) diameter drill bit
• Pencil
• Measuring Tape
• Scissors
• Carpenter's Level

ACCESSORIES

The following accessories are included with
the appliance and should be used during the
installation.
1. 7/16" (11 mm) locking screw and fl at washer
(x2)
2. 1/2" (13 mm) hex-head screw (x7)
3. 1/2" (13 mm) screw and locknut (x4)
4. 3/4" (19 mm) fl at head bolt and locknut (x2)
5. 3/4" (19 mm) screw (x2)
6. 5/16" (8 mm) hex-head locking screw (x10)
7. 1/4" (8 mm) screw (x2)
8. Safety lock for wood window frames
9. Safety lock for vinyl window frames (x2)
10. Sill angle bracket (x2)
11. Frame lock (x2)
12. Foam insert (x4)
13. Window sash foam seal
14. Weather stripping (x5)
1
2
3
4
5
6
7
7
8
9
10
11
12
13
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Dac150eb2wdb-6

Table des Matières