Table des Matières
Publicité
24-HOUR ENROLLMENT DELETION AND
DEFAULT
If the device is enrolled in a panel different than the intended
panel, and you are unable to delete it from the unintended
panel, reset default the device to factory default setting:
1. Open the cover and remove the battery.
2. Insert the battery while holding the test button down for
10 seconds.
This procedure is available for 24 hours after enrollment with
a panel and the device remains powered (battery installed).
WALK TEST THE SIXOCC
After power up and enrollment, the sensor automatically
enters Walk Test mode.
Walk through the detection area and observe the LED.
After 10 minutes, the sensor automatically exits Test mode,
disables the LED and enters normal operation mode.
To restart a 10 minute Test period, activate the Test mode with
the controller (see the Controller's instructions), or use the
flashlight feature (see the following section).
NOTE: the system must be disarmed to enter Test Mode.
When in walk test the LED shows red for intrusion and
green for occupancy.
How do you perform this operation?
24-HOUR ENROLLMENT DELETION AND
DEFAULT
If the device is enrolled in a panel different than the intended
panel, and you are unable to delete it from the unintended
panel, reset default the device to factory default setting:
1. Open the cover and remove the battery.
2. Insert the battery while holding the test button down for 10
seconds.
This procedure is available for 24 hours after enrollment with a
panel and the device remains powered (battery installed).
TEST PAR DÉPLACEMENT DU SIXOCC
Après la mise sous tension et l'enrôlement, activez le mode de
test avec le panneau de commande (voir les instructions du
panneau de commande) ou utilisez la fonction Lampe de
poche.
NOTE: le système doit être dans le mode désarmé avant que
le mode de test de 10 minutes puisse débuter.
Faites le test par déplacement et observez la DEL.
Le mode de test par déplacement est en fonction pendant 10
minutes, après quoi le système quitte automatiquement ce
mode, désactive la DEL et revient au mode normal de
fonctionnement.
Pour redémarrer le mode de test de 10 minutes, utilisez la
fonction Lampe de poche (vois la section suivante).
When in walk test the LED shows red for intrusion and
green for occupancy.
4
Publicité
Table des Matières
