Led Indicators - Honeywell SiXOCC Guide D'installation

Table des Matières

Publicité

LED INDICATORS

GENERAL STATUS
No programmed network (Green LED)
Programmed into a network (Green
LED)
Selection (Red LED)
Warm Up (Red LED)
RED LED
Enter/Exit walk test mode
Trouble /
Tamper
Alarm no Pet Immunity / Panel
programmable
Alarm with Pet Immunity / Panel
programmable
GREEN LED (INTRUSION)
Off
Delete
Tamper/Trouble
GREEN LED (OCCUPANCY)
Occupancy Alarm
GREEN LED DURING THE ENROLLMENT
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE CONTROL WITH WHICH THIS DEVICE IS USED, FOR DETAILS
REGARDING LIMITATIONS OF THE ENTIRE ALARM SYSTEM.
POUR LES LIMITES DU SYSTÈME D'ALARME AU COMPLET, REPORTEZ-VOUS AU GUIDE D'INSTALLATION DU
PANNEAU DE COMMANDE.
PATTERN
100ms ON, 100ms OFF
3s ON / 3s Off
ON selected; OFF when cancel
1s on, 1s Off
20ms ON, 20ms OFF
200ms ON, 4800ms OFF
100ms ON, 100ms OFF
3s ON, 3s OFF
N/A
100ms ON, 100ms OFF
200ms ON, 1800ms OFF
3s ON
3s ON
/ 3s OFF
7
TIME DURATION
OCCASION
Powered on, but never
8 seconds
connected to a network
Power on, connected to a
network (even if already
Continuously?
enrolled into another
network)
When the user select's it,
The time of selection
command from 5168
6-45 seconds
Power on or Reset
Enter or Exit Walk Test
2 seconds
mode
Flash if the error exists
Any trouble condition?
3 seconds
Alarm in walk test mode
3 seconds
Alarm in walk test mode
Normal operation when no
N/A
activity detected
2 seconds
During enrolment
Tamper triggered or
10 minutes
trouble condition?
3 seconds
Alarm in walk test mode
Process is complete and
3 seconds
enrollment confirmed
Any

Publicité

Table des Matières
loading

Table des Matières