Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION MANUAL
INTBUSW
Wiegand door controller
3] MOUNTING KIT
INTBUSW
4] MOUNTING
After checking that the fi tting kit is complete, you can proceed with the fi nal installation of the
product. Collect up the necessary tools (drill, screwdriver, measuring tape, etc) and follow the
INTBUSW door controller fi tting instructions:
1
Insert the 2 plastic anchors in the holes. Then
mount the door controller mounting plate on
your chosen surface using the countersunk
Phillips screws.
Then mount the box on its
support.
Wiring
Varistor
sealing cap
1
INTBUSW housing
2
1
2
Feed your wires through, slide on the door
controller grommets and make your connec-
tions. During this procedure, do not forget to
install the varistor and end-of-loop resistor
(See page 3 «Reminders and recommenda-
tions»).
EN
Mounting plate
for INTBUW housing
cdvi.com
3
cdvigroup.com
Publicité
Table des Matières
