SPARKY HD PROFESSIONAL SM 1236CES Plus Notice Originale page 10

sion cord with proper cross-section.
▪ Check that the auxiliary handle is properly
mounted and reliably tightened.
SWITCHING ON - SWITCHING Off
The sander is secured against unintentional
switching on.
Switching on: Push the back end of the ON/
OFF switch 4 down and then forward in the di-
rection of the arrow until its front end will sag,
thus fixing itself.
Switching off: Press the back, lifted end of
switch 4 and release it to return in its initial posi-
tion.
MOUNTING THE ACCESSORIES
The standard set includes backing pad with
flange nut for direct mounting onto the spindle
and hook-and-loop fixing to the operating tool.
It is possible to deliver the power tool with differ-
ent accessories.
When mounting or dismounting polishing and
sanding tools (accessories) by screwing/un-
screwing onto the spindle, fix the sander spindle
1 by depressing the lock button 2 positioned on
the gear box.
WARNING: Never press the button 2
while the spindle is still rotating!
MOUNTING THE AUXILIARY HANDLE
The auxiliary handle 6 must be always mounted
during any operation with the machine.
The auxiliary handle 6 can be mounted alterna-
tively to the right or left side of the gear box. It is
screwed directly to the machine gear box.
The auxiliary handle 15 is fixed by bolts 17 on
conical washers 16 using spanner 18 directly to
the machine gearbox. The outer cone of wash-
ers 16 shall coincide with the internal cone of
side openings in the handle 15.
fLEXIBLE BACKING PAD
The backing pad 5 can be screwed directly onto
the spindle. The hook-and-loop operating tools
14 (sandpaper, polishing sponge, felt wheel,
lambswool pad, etc.) can be fixed directly onto
the backing pad.
To dismount (unscrew) the backing pad use a
spanner when necessary.
To use the machine with the backing pad with
a fixing flange 7 place the support flange 8, the
8
EN
backing pad 7 and the sandpaper 10 onto the
spindle. Tighten the fixing flange 9 using a pin
spanner 12.
fIXING THE OPERATING TOOL TO THE
HOOK-AND-LOOP (VELCRO) BACKING
PAD
The operating tool fastened to the backing pad
shall be Ømin148. The operating tool shall be
aligned with the backing pad and care shall be
taken to ensure their coaxiality. Eccentrically
mounted operating tools cause wobbling and
vibrations.
WARNING: Use only pads with un-
damaged hook-and-loop system. Perform a
trial test for at least 30 sec at no load after
replacing the backing pad.
WARNING: Vibrating or otherwise
improperly rotating backing pads must be re-
placed immediately!
WIRE BRUSH
The machine can be operated with cup/wheel
wire brush with M14 thread.
Screw the wire brush onto the spindle 1 and
tighten it by the spanner.
LAMBSWOOL POLISHING PAD
Place the lambswool polishing pad on the back-
ing pad 5 and ensure their coaxiality.
Fix the lambswool pad on the backing pad by
hook-and-loop system (VELCRO).
fELT POLISHING WHEEL AND POL-
ISHING SPONGE WITH fLANGE
Screw the felt wheel or the sponge with flange
onto the spindle 1.
CLOTH WHEEL (BUff)
The cloth wheel can be fastened by a carrier
consisting of threaded stud with opening, sup-
port flange and fixing flange. To mount the cloth
wheel screw it onto the spindle.
SM 1236CES Plus ● SM 1433CES Plus