Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
simalube 15
Dispensing
time (days)
ml/day
Temperature
–20 °C
4 °C
20 °C
40 °C
55 °C
+ use larger dispenser with longer dispensing time
– smallest possible output rate reached
The values relate to laboratory conditions, SL01 with no counterpressure. At low
tempe ratures in particular, the values may vary between one grease type and
another. The dispensers must be replaced once the dispensing time set has expired,
even if they are not completely empty.
The grease quantity dispensed
per day is influenced by:
Start-up time:
The lubricator requires a certain start-up time until the lubricant is first dispensed.
The start-up time varies in line with the volume dispensed and operating tempera-
ture selected.
Notes:
In order for the unit to function reliably, it is important to have clear, filled grease
lines. It must be ensured that the grease lines are not blocked. Consequently,
the grease lines should always be cleared with a grease gun before starting. The
simalube can be re-adjusted or switched off during operation. Depend ing on the
temperature and setting, it may take a few days until the lubricant is first dispensed.
The user must check the operation of the simalube regularly.
Grease lines should be no longer than 0.5 m. Recommended bore diameter:
6 – 8 mm. Resistance in grease lines has to be minimized, narrow passages and
right angles should be avoided.
The simalube may only be used to supply a single grease point. No branches may
be made. Once the lubricator is installed and activated, it must not be removed and
mounted onto another lubrication point.
Recycling Instructions
30
90
0.50
0.17
Setting
Setting
+
2
+
2.5
1
3
1
3
1
3.5
41
ALU
180
0.08
Setting
3.5
5
6
6.5
7
– counter pressure/resistance from
the grease lines
– ambient temperature
– viscosity of the grease
1) Unscrew gas generator and dispose
of complete unit for battery recycling
(see above).
Note: Do not detach lubricator near
an open flame.
2) Dispose of empty housing in alu-
minium recycling. If the lubricator still
contains lubricant after use, please
dispose of it in accord ance with local
regulations.
10
270
360
0.06
0.04
Setting
Setting
5.5
7.5
7.5
10.5
9
12
9.5
–
10.5
–
Publicité
Table des Matières
