Connecting A Seperate Bell Button; Melody Selection With Wired Gong Module - REV 0514983555 Mode D'emploi

9. Connecting a seperate bell button

(Only for transmitter type 04281R2)
The separate bell button may not be connected with an existing bell
system. The battery must remain in the transmitter.
The connection clips A & B are connected for this purpose with a dual-
core wire system to the bell button. The bell button used must be unlit.
Any available fluorescent or electric light bulbs must be removed.
Sender Typ 04281R2
A
A
B
B

10. Melody selection with wired gong module

The bell connected to T3 and T4 enables the gong to play a stipulated
polyphone melody or alternating polyphone melodies.
On pushing the slide switch (7) to „SEQ" the „SEL " button (6) can be
pressed to select the desired polyphone melody. To ensure that the
gong only plays this selected melody the slide switch (7) must be
pushed to the „SET" position without having pressed any other buttons
in the meantime. If the slide switch remains in the „SEQ" position any
random polyphone melody is played.
Note: On changing the battery or changing a module respectively the
melody is automatically reset to a standard melody and must be reset
if necessary.
19