ARENDO 304831 Mode D'emploi page 31

11. Troubleshooting
Error
The appliance
is not working
correctly
The blade unit is
rotating slowly
The content is
not blended
properly
The blender jar
is leaking
12. Safety instructions and disclaimer
Never try to open the appliance to repair or make modifications. Avoid contact
with the mains voltage. Do not short-circuit the product. The appliance is not wa-
terproof, therefore please use it only in dry surroundings. Protect it from high hu-
midity, water and snow.
English
Cause
• Appliance is not con-
nected to the power
supply
• Appliance is not
switched on
• The appliance is
overheating
• Too much content in
the blender jar
• Appliance is defective
• Too much content in
the blender jar
• Not enough liquid in
the blender jar (appli-
ance is overheating)
• Large pieces in the
blender jar
• Too much content in
the blender jar
• Parts are not mounted
properly
• sealing ring is not
present on the lid
• damaged sealing ring
on the lid
Troubleshooting
• Connect the power supply to
the appliance
• Switch on the appliance
• Allow the appliance to cool
down adequately after use
• Remove some contents from
the blender jar
• Contact our customer service
in case of defects
• Remove some contents from
the blender jar
• Allow the appliance to cool
down adequately after use
• Remove some contents from
the blender jar
• Chop the content into smaller
pieces if required
• Check and mount the parts
carefully
• Mount the sealing ring
• Replace the sealing ring with a
new and proper sealing ring
31