Klarstein MAXFLOW SMART Mode D'emploi page 25

• Remove the plug from the wall outlet.
• Catch the filtration mesh handle and take it out.
• Clean the filtration mesh with mild detergent and softbrush.
• Make sure the filtration mesh is completed dry beforeinstalling.
Cleaning the water tank
• Remove the plug from the wall outlet.
• Pull out the water tank.
• Clean the water tank with mild detergent and soft brush.
• Put the water tank in place and fix it after cleaning.
Note: Pay attention to the pump, it may fall down when pulling out the tank, please
put the pump in place before placing the tank back.
Replacement of Honeycomb Filter
• Take out the filtration mesh (Fig 1).
• Unscrew the 2 pcs screw ST2.9*14 (Fig 3).
• Replace the honeycomb filter with HEPA filter (bought from the agent only) , then
assemble the filtration mesh back, use it as air purifier and air cooling fan.
Fig. 1
pump falls down pump in place
Fig. 2
EN
ST2.9*14x2
Fig. 3
25