Maintenance And Service; Bag Full Indicator; Changing The Paper Bag; Changing The Filters - Kärcher WINDSOR 1.012-070.0 Mode D'emploi

Masquer les pouces Voir aussi pour WINDSOR 1.012-070.0:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance
29
15
30
47
16
4
46
37
38
86400000 - Sensor2

Maintenance and Service

ALWAYS unplug from the mains socket before
dismantling any part of the machine.

Bag Full Indicator

If the warning indicator (4) turns orange, it indicates
that there is a reduced air flow. This is caused either
by dirty filters, a blockage in the hose or base of the
machine, or a full paper bag. When picking up fine
dust, it may be necessary to change the dust bag
before it is full. Fluff or hair lets air pass through
easily, the bag may overfill before the full indicator
comes on.

Changing the Paper Bag

To change the paper bag, press the catch (15) and
remove the bag cover (29). Push the lever (30) over
to the right. Then change the bag, as illustrated on
front of bag. Ensure that the bag top (47) is located
properly on both sides of the holder (46) and pushed
until it locks. The used paper bag can be sealed with
a cap.
NOTE: Do not re-use paper bags.
NOTE: Use only manufacturer approved filters and
bags
To fit a new dust bag, Slide the right side of the bag
top into the holder (46) and fit the dust inlet of the bag
top (47) over connecting tube until the filter bag
latches into the lever.

Changing the Filters

The Microfilter (37) is located in the dust bag
compartment. To change the Microfilter slide it out.
Please ensure no particles fall down into the swivel
neck. To insert a new Microfilter (37) lift the metal
bar (38) to slide the filter in.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Windsor 1.012-071.0

Table des Matières