Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2 4
3 2
3 6 "
DUCTING
A minimum of 7" round or 3-1/4" x 10" rectangular
Always use rigid type metal ducts only. Flexible
available duct run when using elbows, transitions
and caps.
ALWAYS, when possible, reduce the number or
transitions and turns. If long duct run is required,
increase duct size from 7" to 8".
If turns or transitions are required; install as far
away from hood duct output and as far apart,
between the two as possible.
Minimum mounting height between range top to
hood bottom should be no less than 24".
Maximum mounting height should be no higher
than 32".
It is important to install the hood at the proper
mounting height. Hoods mounted too low could
mounted too high will be hard to reach and will
i n .
If available, also refer range manufacturer's height
" m
a x .
clearance requirements and recommended hood
" m
mounting height above range.
DAMAGE-SHIPMENT / INSTALLATION:
• Please fully inspect unit for damage before
installation.
• If the unit is damaged in shipment, return the
unit to the store in which it was bought for
repair or replacement.
• If the unit is damaged by the customer, repair
or replacement is the responsibility of the
customer.
be made by arrangement between customer
and installer.
6
www.zephyronline.com
Vertical Ducting:
7" round minimum or
3-1/4" x 10" rectangular minimum
Horizontal Ducting:
3-1/4"x10" rectangular minimum
Publicité
Table des Matières
