Jenn-Air JBZFR18IGX Installation page 7

T O O L S + P A R T S
N O T P R O V I D E D
T O O L S
 Cordless drill and drill bits or impact driver
 Drill bit set including 3/32" and 1/8" diameter bits
 Two adjustable wrenches
 #2 Phillips bit
 1/4" magnetic nut driver
 #2 square-drive bit
 48" or longer level or straight edge
(Can substitute a factory-installed trim
piece, once removed.)
 3/8" and 1/2" open-end wrenches
 Tape measure
 Utility knife
 Masking tape
 Appliance dolly
 Right angle drill adapter
 6" drill extension
 #8 pan head wood screws of assorted lengths
including 1", 1-1/4", 1-1/2"
W H Y U S E
R O T T E R
S Y S T E M
S H I M S
A N D T H E
B A D A S S
B R A C K E T ?
This recommended process might be unfamiliar to
you as an installer, but it adds enormous value to both
you and your client. Use the Rotter system to:
• Help position column without scratching
• Create precise 1/8" reveals on each side
• Always have ready-made shims tailored to each site
• Keep column stable in cutout over lifetime
• Eliminate misalignment issues for your client
P A R T S
 Flexible code-approved water supply line
 Custom door panels
• Stainless steel panels: order from JennAir
• Custom wood panels: consult a qualified
cabinetmaker or carpenter
 Additional fasteners will be required according
to the kitchen furniture construction
I N T R O D U C T I O N
7