Charging The Batteries - ProTeam GoCartVac 1060870 Manuel Du Propriétaire

CHARGING THE BATTERIES

OFF
1. Make sure the power switch on the rear of the cart is in the OFF (0) position (Figure A).
2. Plug extension cord plug into cord plug port on the rear of the cart (Figure B).
3. Plug other end of extension cord into 120 V wall outlet. (Figure C).
4. Turn pump handle switch to OFF position for duration of charge cycle, or disconnect the hose
cord from cover of GoCart for duration of charge cycle. (Figure D)*.
5. Turn switch on rear of cart to ON (I) position. Charge until green light comes on (Figure E).
OFF
Figure A Figure B
CHARGE LIGHTS
Red – Charging has started.
Yellow – Final charging is in progress.
Green – Battery is fully charged and
ready to use.
CAUTION
The average recharge time depends on the battery charge level. If the battery is completely
depleted, the recharge time is approximately 3.5 hours.
You may vacuum with the GoCartVac plugged into the wall outlet. The batteries will recharge
while you use the vacuum. The recharge time while using the vacuum is approximately 5.5 hours.
The GoCartVac is equipped with a solid state detector which monitors the Charge state of the
batteries. The detector will automatically turn the vacuum OFF when the battery level is too
low to continue operation. This detector has been implemented to prevent the batteries from
being overly discharged, which reduces battery life and results in prolonged recharge time.
PROPER STORAGE & CHARGING
1. When the vacuum is not in use, it should be stored in a dry place.
2. Plug the GoCartVac into the wall outlet so it is recharged for the next use.
3. Turn hose switch into OFF position or disconnect hose cord from cover of GoCart*.
4. Place the power switch on the cart in the ON (I) position, or the batteries will not recharge.
5. Wrap the hose around the hose wrap.
6. EMPTY OR REPLACE THE INTERCEPT MICRO FILTER AFTER EACH USE.
*If the hose switch is not turned off or hose cord unplugged during charging; turn hose switch to off
position for minimum of 60 seconds before operating. This resets the electronics.
8
Figure C
(Figure F)
Figure F
The power switch on read of the cart should be
placed in the OFF (0) position when plugging and
unplugging the extension cord into a wall outlet
(Figure A).
Figure D Figure E
ON
View Lights
on charger
to check
progress:
ProTeam