Cleaning And Maintenance - Philips ErgoFit FC9269 Mode D'emploi

English
10
using the filter-cleaning handle to clean the filter cylinder (specific types only)
1 Switch off the appliance and unplug it (Fig. 20).
2 Keep the appliance in horizontal position, with all wheels touching the floor.
3 Press the cover release button (1) and open the cover (2) (Fig. 22).
4 Turn the filter-cleaning handle until it has made 6 full circles (Fig. 23).
5 Close the cover firmly ('click').
using the autoClean button to clean the filter cylinder (specific types only)
Always press the AutoClean button when you have finished vacuum cleaning.
Make sure the dust bucket, the filter cylinder and the filter cylinder case are installed properly
and the cover is closed properly.
1 Switch off the appliance. Leave the mains plug in the wall socket (Fig. 20).
2 Keep the appliance in horizontal position, with all wheels touching the floor.
3 Press the AutoClean button on the remote control on the handgrip (Fig. 24).
You hear a beep and the filter-cleaning process starts.
,
During the filter-cleaning process, the appliance produces a rattling noise. This is completely
,
normal.
When the filter-cleaning process is finished, you hear a beep.
,
using the autoClean button during vacuuming (specific types only)
You can also press the AutoClean button during vacuum cleaning. When you do this, the motor
stops running and the filter-cleaning process starts. During the filter-cleaning process, the appliance
does not suck up dirt. When the filter-cleaning process is finished, the motor automatically starts
running again and you can continue vacuum cleaning.
reminder to clean the filter cylinder
You have to clean the filter cylinder after each vacuuming session. This prevents the filter cylinder
from clogging and helps maintain optimal suction power.
- If you fail to clean the filter cylinder a number of vacuuming sessions in a row, the filter
light flashes for 15 seconds. (Fig. 25)

Cleaning and maintenance

Cleaning the dust bucket and filter cylinder unit
Always unplug the appliance before you empty the dust bucket.
The dust bucket is not dishwasher-proof.
Empty the dust bucket as soon as the dust level has reached the round disc of the filter cylinder
case.
1 Switch off the appliance and remove the mains plug from the wall socket.
2 To disconnect the hose, press the release button (1) and pull the hose out of the appliance
(2) (Fig. 26).
3 To unlock the cover, press the cover release button. Swing open the cover.
4 Lift the dust bucket out of the appliance (Fig. 27).
5 Press the release button for the filter cylinder unit on the bucket handle (1) and remove the
filter cylinder unit (2) (Fig. 28).