CDVI EACP105E Manuel D'installation page 9

installation manuEl installation manual
Eacp105E
GalEo
Illuminated RF Keypad
Electronic control panel for two 230Vac motors
10b] single gate programming
2 sec.
p2
pG1
press pG1 : gate
starts the slow down
pG1
(*)
press pG1 :
gate stops
pG1
(*) NOTE : The programming of the panel, without slow down ( dip-switch 7 = OFF ) is similar to the
programming with the slow down, except for the pressure of the buttons PG1 & PG2 next to the limits, that in
this case is missing.
A sequence of 2 pressures of P3 can assign to key A of the transmitter the CH1 of the RX card ( Normal opening
) and to key B the CH2 of the RX card ( Pedestrian opening ).
11a] adding a transmitter using the button p3 of the rX card
lr
press
4 sec.
p3
Beep
To enter the programming press P2 for 2 sec LED L3 lights up.
l3
press pG1 :
gate starts
press button a
Beep
press pG1 :
gate starts
closing
End of the procedure
lV
press button B
press
p3
Beep
press pG1 : gate
starts the slow
down (*)
pG1
press pG1 :
gate stops
pG1
lV x 5sec.
--> off
Beep
erone.com
En
9