CDVI EACP105E Manuel D'installation page 7

installation manuEl installation manual
Eacp105E
GalEo
Illuminated RF Keypad
Electronic control panel for two 230Vac motors
9] dip-switch settings
N° Function
Automatic
1
closing
Condominium /
2
step-by-step
3 Not used
4 Opening Jolt
Contact safety
5
in opening
Flashing
6
function
7 Slow down
Periodic closing
8 command for
security
NOTES
• Safety edge, connected on terminals 15-17 - This contact protects opening and closing.
DIP 5 ON: When there is an obstacle, the motors stop and reverse for 2 sec.
DIP 5 OFF: When there is an obstacle motors STOP.
In both cases after the disengagement resumes the opening.
• Photocells, connected on terminals 16-17 - This contact protects only in closing : when there is an
obstacle the motors STOP;
• Emergency Stop connected on terminals 21-23 - The contact, if open, will cause the immediate stop of
the automation in any situation.
FLASHING LIGHT
If Dip6=ON then: IN OPENING: blinking slow
IN CLOSING: blinking fast
IN PAUSE: steady light
PHOTOCELL ENGAGED: Turn off
Dip-switch Pos
ON Automatic closing activated
OFF Automatic closing disabled
ON During opening does not accept further commands
OFF Command : OPEN/STOP/CLOSE/STOP
ON
Not used
OFF Not used
ON Opening jolt enabled
OFF Opening jolt disabled
NC contacts (15-17), stop & invert for 2 sec on opening, stop & invert
ON
the direction on closing
NC contacts (15-17) stop the movement on opening, stops & inverts
OFF
on closing
ON Warning light blinking
OFF
Warning light fixed
ON slow down mode at the end of each manouvre ( opening and closing )
OFF
No slow down : full torque
Every 180 min, the panel gives a closing command, avoiding any
ON
gate-opened situation
OFF Function disabled
Description
erone.com
En
7