Mains Connection; Network Connection - auna WORLDWIDE 10026443 Mode D'emploi

Inserting batteries into the RC
• Press the battery compartment gently according to the direction in dicated in the illustration.
• Slide to open the battery compartment.
• Insert the supplied CR2032 battery into the compartment according to the polarity markin gs („+" and
„-") inside the compartment and on the battery. Replace the battery compartment until it clicks.
Please note: Remove the protective plastic strip inserted in the battery compartment, when using for the
first time.
BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
• Warning -Danger of explosion if battery is incorrectly replaced. Replace only with the same or equiva-
lent type.
• Use only the size and type of battery specified.
• Be sure to follow the correct polarity when installing the battery as indicated in the battery compart-
ment. A reversed battery may cause damage to the device.
• lf the device is not to be used for alang period of time, remove the battery to prevent damage or injury
from possible battery leakage.
• Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (follow
battery manufacturer's directions.)
• Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Insert the DC power jack of the AC/DC adaptor to the DC in socket located at the back of the unit. Plug the
AC/DC adaptor to the AC mains outlet.
Wired network:
• Check first of all whether the control lamps (LINK/ACT) of your LAN connection or your router light up.
• Use an Ethernet cable with RJ45 connector to connect the NETWORK socket of the radio with the LAN
port of your router.
• Proceed for the operation as described in the below "GETTING STARTED". But no need to run through
the setup wizard
Note: Information on the LAN connection can be obtained from the user manual of the router manu-
facturer.
Operation: First Steps

Mains Connection

Network Connection

23
www.auna.de