1_Stick_VS8000-V2_EN_00803K-00_SW.indd 15
Installing the wall mount
CAUTION
• The wall mount's mounting screws must be affixed to a hard wall or
underlying wall stud.
– If you install the wall mount on a plaster board wall, you must screw the
supporting screws into an underlying stud.
Installing the wall mount
Groove for fixing
the wall mount
118 cm
Disassembling the wall mount
1
4
❇ When re-assembling the wall mount, make sure the cables are placed as shown in the
illustration.
01 Remove the rubber cap from the
02 Set the height of the wall mount
03 Using the wall mount as a template,
04 Drill the holes using a 6 mm drill bit.
Screws
Screw
Anchors
05 Plug in the wall mount, place the
2
01
02
5
groove for fixing the wall mount.
installation so that top of the wall
mount will be 118 cm from the floor.
mark where the top and bottom screw
holes will be placed.
Fix the wall mount to the wall with the
provided screws. Re-Insert the rubber
cap into the groove for fixing the wall
mount.
vacuum into the wall mount, and then
confirm that the battery level indicator
is on.
3
❇
02
01
English
15
2018-03-08 오후 1:47:17