Safety Precaution; Installation Instructions - Refsta Puro Plus 600 Notice D'utilisation

démarre en 1 vitesse pour 10 minutes pendant lesquelles les
ère
boutons F et C doivent clignoter en même temps. A la fin de
ce temps, le moteur s'arrête et la diode électroluminescente
du bouton F reste allumée sans clignoter jusqu'à ce que le
moteur reparte en 1 vitesse 50 minutes plus tard. Les diodes
ère
électroluminescentes F et C recommencent à clignoter pen-
dant 10 minutes et ainsi de suite. En appuyant sur n'importe
quelle touche à l'exception des touches de lumière, la hotte
retourne immédiatement à son fonctionnement normal (ex. en
appuyant sur le bouton D la fonction «clean air» se désactive
et le moteur passe directement à la 2
sur le bouton B la fonction se désactive).
(*) La fonction "MINUTER ARRÊT AUTOMATIQUE" retarde
l'arrêt de la hotte, qui continuera de fonctionner à la vitesse de
service en cours au moment de l'activation de cette fonction,
pendant 15 minutes.
• Saturation filtres Anti-graisse/Charbon actif:
- Lorsque la touche A clignote avec une fréquence de 2
secondes, les filtres anti-graisse doivent être lavés.
Lorsque les filtres nettoyés sont remis en place, réinitialisation
la mémoire électronique en appuyant sur la touche A pendant
environ 5 secondes jusqu'à ce qu'elle arrête de clignoter.
- Lorsque la touche A clignote avec une fréquence de 0,5
secondes il ne faut rien remplacer, car cette hotte est équipée
d'un système d'épuration d'air indépendant, pour lequel il faut
réinitialiser la mémoire électronique en appuyant sur la touche
A pendant environ 5 secondes jusqu'à ce qu'elle arrête de
clignoter.
NOUS DECLINOS TOUTE RESPONSABILI TE POUR LES
EVENTUELS DÉGATS PROVOQUÉS PAR L'INOBSERVATION
DES SUSDITES INSTRUCTIONS.
ENGLISH
GENERAL
Carefully read the following important information regarding
installation safety and maintenance. Keep this information
booklet accessible for further consultations. The appliance has
been designed for use in the filtering version (air circulation
on the inside - Fig.1).

SAFETY PRECAUTION

1. Take care when the cooker hood is operating simultane-
ously with an open fireplace or burner that depend on the air
in the environment and are supplied by other than electrical
energy, as the cooker hood removes the air from the environ-
ment which a burner or fireplace need for combustion. The
negative pressure in the environment must not exceed 4Pa
(4x10-5 bar). Provide adequate ventilation in the environment
for a safe operation of the cooker hood. Follow the local laws
applicable for external air evacuation.
Before connecting the model to the electricity network:
- Control the data plate (positioned inside the appliance)
to ascertain that the voltage and power correspond to the
network and the socket is suitable. If in doubt ask a qualified
electrician.
- If the power supply cable is damaged, it must be replaced with
another cable or a special assembly, which may be obtained
direct from the manufacturer or from the Technical Assistance
Centre.
vitesse ; en appuyant
ème
GB
- 15 -
- This device must be connected to the supply network through
either a plug fused 3A or hardwired to a 2 fase spur protected
by 3A fuse.
2. Warning!
In certain circumstances electrical appliances may be a
danger hazard.
A) Do not check the status of the filters while the cooker
hood is operating.
B) Do not touch bulbs or adjacent areas, during or straight
after prolonged use of the lighting installation.
C) Flambè cooking is prohibited underneath the cooker
hood.
D) Avoid free flame, as it is damaging for the filters and a
fire hazard.
E) Constantly check food frying to avoid that the over-
heated oil may become a fire hazard.
F) Disconnect the electrical plug prior to any maintenance.
G) This appliance is not intended for use by young children
or infirm persons without supervision.
H) Young children should be supervised to ensure they do
not play with the appliance.
I) There shall be adequate ventilation of the room when
the rangehood is used at the same time as appliances
burning gas or other fuels.
L) There is a risk of fire if cleaning is not carried out in
accordance with the instructions.
This appliance conforms to the European Directive EC/2002/96,
Waste Electrical and Electronic Equipment (WEEE). By making
sure that this appliance is disposed of in a suitable manner, the
user is helping to prevent potential damage to the environ-
ment or to public health.
The symbol on the product or on the accompanying
paperwork indicates that the appliance should not be
treated as domestic waste, but should be delivered to
a suitable electric and electronic appliance recycling collection
point. Follow local guidelines when disposing of waste. For
more information on the treatment, re-use and recycling of
this product, please contact your local authority, domestic
waste collection service or the shop where the appliance was
purchased.

INSTALLATION INSTRUCTIONS

• Assembly and electrical connections must be carried out
by specialised personnel.
• Wear protective gloves before proceeding with the
installation.
• Electric Connection:
Note! Verify the data label placed inside the appliance:
- If the symbol appears on the plate, it means that no earth
connection must be made on the appliance, therefore follow
the instructions concerning insulation class II.
- If the symbol DOES NOT appear on the plate, follow the
instructions concerning insulation class I.
Insulation class II
- The appliance has been manufactured as a class II, therefore
no earth cable is necessary. The plug must be easily accessible
after the installation of the appliance. If the appliance is equip-
ped with power cord without plug, a suitably dimensioned
omnipolar switch with 3 mm minimum opening between con-
tacts must be fitted between the appliance and the electricity
supply in compliance with the load and current regulations.
- The connection to the mains is carried out as follows: