Cleaning And Maintenance - Bimar JFD-121 Notice D'instructions

AC/DC adapter
-
To operate the fan, insert the adapter plug into the socket on
the base (1) all the way down, and insert the plug into the socket
(you will hear a "beep" indicating that the unit is in stand-by
mode). To activate the fan press the "
the required functions.
To de-activate the unit, press the "
" will remain lit. To turn the unit off, remove the plug from
the socket.

CLEANING AND MAINTENANCE

Attention: before normal cleaning, remove the plug from the socket.
• Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or other liquid: if this should happen, do not
put your hand in the liquid, but first remove the plug from the socket. Carefully dry the
appliance and make sure that all the electrical parts are dry: in the case of doubt, ask for
professionally qualified help.
• It is essential that the motor's air holes be kept from dust and lint.
• Cleaning the propeller (take the figures as reference): remove the fixing screw, turn the
grille clockwise (direction): ⇒ OPEN), unscrew the ring nut and remove the propeller
outwards. Use a soft, slightly dampened cloth for cleaning; do not use abrasive or
corrosive products. To reassemble: insert the propeller on the motor shaft all the way
down, lock it with the appropriate ring nut by tightening it (anticlockwise), couple the
front grille to the rear one, turn the front grille (direction ⇐ LOCK) and lock it with the
screw. When finished, always make sure that all parts are correctly assembled.
• If the fan will not be used for long periods, it must be protected from dust and humidity;
we recommend storing it in its original packaging.
• Should you decide not to use the appliance any more, we recommend making it
inoperative by cutting the power cord (after making sure you have disconnected the plug
from the socket) and make dangerous parts harmless if children are allowed to play with
them (such as the blade).
" button and select
" button: the symbol "