Hikmicro HM-TP21-6VF W-M10 Guide De Démarrage Rapide page 4

Component
Laser Button
Lens Sheet Button
Back Button
Focus Knob
Trigger
Cable Interface
3. Charge Device
After the device starts up, the OSD (on-screen display) shows the battery status. When the battery is low, charge
the device and ensure it works properly.
For the first charge, charge the device for 48 to 72 hours when the device is turned on.
3.1 Charge Device via Cable Interface
Steps
1. Lift the cover of interface.
2. Plug in the cable, and charge the device.
3.2 Charge Device via Charging Base
You need to purchase charging base.
Steps:
1. Hold the device, and press both battery lock catches of the device.
2. Hold the lock catches, and draw the battery base to take out the battery.
3. Insert the battery into the charging base. You can see the charging status via the pilot lamp on the charging
base.
Hold the button to turn on laser, and release the button to turn off laser.
Cover the lens to perform the correction.
Exit the menu or return to previous menu.
Adjust lens focal length.
Pull the trigger to capture. Hold the trigger to record videos.
Charge the device or export files with supplied cable.
Function
2