ASBER EASY-350 Manuel D'instructions page 50

asberprofessional.com
Machine stops during op‐
eration.
Machine stops and fills with
water when it is washing.
The machine does not start
with the wash cycle.
n
asberprofessional.com
49
Traces of salt in tub.
Electrical installation
overloaded.
Machine
has tripped.
Door opens.
Pressure switch pipe
blocked.
Pressure switch faulty. Call the technical service to replace it.
Overflow incorrectly
mounted.
Door is not closed
properly.
Door micro switch
faulty.
NOTE: If a fault occurs and is not listed in the above table, please call
the technical service. The manufacturer reserves the right to modify
the technical characteristics with prior warning.
When filling the salt deposit, take care not to spill
salt in the tub.
Call technical service to modify electrical installa‐
tion.
protection Reset safety device and if it trips again, call techni‐
cal service.
Call the technical service to repair it.
Empty the tub and clean thoroughly.
Mount overflow correctly.
Close the door properly and if it opens alone, call
the technical service.
Call the technical service to replace it.
ENGLISH