asberprofessional.com
The required temperature of the machine is 85 ⁰C / 185 ⁰F in the rinse boiler and 60 ⁰C / 140 ⁰F in the
wash tub. ASBER recommends that the water in the glass washer is changed every 40/50 washes or
twice a day.
The machine you have purchased is fitted with a safety thermostat on the boiler, so that, if the main
thermostat fails, the safety thermostat is able to disconnect the boiler heating.
6.1.3
Preparation of the dishes
Before washing the dishes, the preparatory steps below should be followed:
•
•
•
•
•
•
6.1.4
Selecting the wash cycle.
Before starting the wash cycle, place the corresponding basket containing the dishes in the machine.
Before starting the wash process, the position of the control switch must be changed, or the pre-
selected wash time is maintained when the machine is switched on. Then close the door and press
the start cycle button. Figures 8 and 9 show the different positions of the wash cycle selector switch.
Please refer to the correct model.
6.1.4.1 Thermo‐stop
The machine you have purchased is not fitted with the thermo-stop function. This is only fitted in
higher ranges.
asberprofessional.com
44
The door must be closed for the machine to start filling. For safety
reasons, if the door is open, the machine will not fill.
During the first heating of the day, the boiler may reach a higher
temperature than that mentioned above due to heating inertia. This is
normal. If pressurised steam is observed coming out of the rinse
branch nozzles, while the boiler is heating, the technical service should
be notified.
Remove the largest pieces of waste from the dishes before placing them in the baskets.
Wash glassware first.
Put the small plates in the rack basket.
Place the glasses upside down.
Place the cutlery in the cutlery baskets with the handles downwards. The different pieces of
cutlery can be mixed.
Place the cutlery baskets in the lower baskets.
The door must be closed for the machine to start the wash cycle. For
safety reasons, if the door is open, the wash cycle will not fill.
ENGLISH