Home Skinovations Silk'n Jewel H3210 Mode D'emploi page 16

I
Be sure to cover up moles, warts or other marks on the skin that
should not be treated.
2. Press the control button. The device will turn on, the level 1 energy
EN
indicator light will be on, and a fan sound will start.
3. Approximately 1 second after pressing the control button, the ready light
will turn on (#4 in the diagram). The device is then ready to use at the
lowest energy level.
4. Set the energy level. Press the control button repeatedly to increase
the energy level until you have the level you want. The energy level
indicator lights indicate the energy level setting (refer to section "8.2
Energy Levels").
5. Decide if you wish to treat the area by Gliding or Pulsing.
6. Apply the treatment surface to the skin (#6 in the diagram). Make sure
that the skin is spread evenly and smoothly. When the treatment surface
is in full contact with the skin, the ready light will start blinking slowly.
7. The device will first determine the color of your skin automatically and it
will flash a pulse of light onto your skin. You will feel a mild sensation of
warmth and tingling, and you may hear a popping sound.
I
If the skin is very dark, the device will set itself to energy level 1
automatically. There will be a short delay before the pulse.
I
If you are pulsing, remove the device from your skin. If you are
gliding, simply continue.
The device will immediately recharge for the next pulse. After a few
seconds (depending on the energy level) the ready light will turn
on again, and start blinking slowly when pressed against the skin.
8. If you are pulsing, repeat the process. If you are gliding, simply continue.
9. Continue to pulse or glide until you have treated the area fully.
Stop use immediately, if your skin blisters or burns.
J
J
16