Smartpond 36122 Mode D'emploi page 6

Step 1. Disconnect the transformer from
the outlet, and remove the metal lotus
fogger from your water feature.
Step 2. Remove the fogger from the metal
lotus. Remove the fogger cap by inserting a
small screwdriver through the side opening
and rotate counterclockwise to unlock.
NOTE: Small screwdriver not included.
Step 3. Carefully lift the retaining ring up.
Remove the old ceramic disc and replace
with a new one. Make sure the O-ring is in
place without any kinks or water on it.
Step 4. Carefully reinstall the fogger cap
with the small screwdriver. Do not over
tighten.
Step 5. Place the fogger back into the
metal lotus. Place the metal lotus fogger
into the water and plug the transformer into
a properly grounded electrical outlet.
TROUBLESHOOTING
• If fogger fails to work, check that the fogger is getting power by
testing another appliance in the same power outlet.
• The fogger must be placed in the float for optimum operation. Placing
the fogger at any other water depth will result in poor operation.
• The sensor on the fogger must be submerged for the fogger to
activate.
• If the lights are working, but there is no or less than normal misting
effect, it is time to replace the ceramic disc. Replace the ceramic
disc as necessary or after every season for optimal performance.
4
VISIT WWW.SMART-POND.COM FOR PRODUCT INFORMATION AND TIPS.
GFCI
outlet
Ceramic
Disk
Retaining
Ring
O-ring
GFCI
outlet
1
2
Sensor
3
4
5