Residual Risk; Know Your Product - Ryobi ONE+ OLT1833 Traduction Des Instructions Originales

WARNING
Servicing requires
knowledge and should
only by a qualifi ed service technician. For
service, we suggest you bring the product
to your nearest authorized service center for
repair. When servicing, use only identical
replacement parts.
■
Switch off and remove the battery the pack
before conducting any maintenance or
cleaning work.
■
You may make adjustments and repairs
described in this manual. For other repairs,
contact the authorised service agent.
■
For replacement line, use only nylon
filament line of the diameter described in
the specification table of this manual
■
After extending new cutter line, always
return the product to its normal operating
position before starting.
■
After each use, clean the product with a
soft dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorised service centre.
■
Check all nuts, bolts, and screws at frequent
intervals for proper tightness to ensure the
product is in safe working condition. Any
part that is damaged should be properly
repaired or replaced by an authorised
service centre.
■
Bring the product to an authorised service
centre to replace damaged or unreadable
labels.

RESIDUAL RISK

Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise in use and the operator
should pay special attention to avoid the
following:
■
Injury caused by vibration
– Hold the product by designated handles
and restrict working time and exposure.
■
Injury caused by exposure to noise
4 | English
extreme care and
be performed
– Wear hearing protection and limit
exposure.
■
Injury caused by flying debris.
– Wear eye protection at all times.
RISK REDUCTION
It has been reported that vibrations from
handheld tools may contribute to a condition
called Raynaud's Syndrome. Symptoms may
include tingling, numbness and blanching of
the fi ngers, usually apparent upon exposure
to cold. Hereditary factors, exposure to cold
and dampness, diet, smoking and work
practices are all thought to contribute to the
development of these symptoms. There are
measures that can be taken by the operator to
possibly reduce the effects of vibration:
■
Keep your body warm in cold weather.
When operating the product, wear gloves
to keep the hands and wrists warm. It is
reported that cold weather is a major factor
contributing to Raynaud's Syndrome.
■
After each period of operation, exercise to
increase blood circulation.
■
Take frequent work breaks. Limit the
amount of exposure per day.
If you experience any of the symptoms of this
condition, immediately discontinue use and
see your physician.
WARNING
Injuries may be caused, or aggravated, by
prolonged use of a tool. When using any
tool for prolonged periods, ensure you take
regular breaks.

KNOW YOUR PRODUCT

See page 154.
Parts
1. Rear handle
2. Trigger
3. Flailing blade accessory
4. Telescoping collar
5. Charger
6. Battery latch button
7. Battery pack