golmar Vista Plus CD-PLUS/R5 Manuel D'installation page 38

CONFIGURATION
D D
e e scription of the configuration dip switch. scription of the configuration dip switch.
The SW1 configuration dip switch is located in the upper
right part of the module.
The operation mode of the converter is defined according to the dip switch 2 and 3
combinations:
Backbone encoder (Master):
Activate this mode if you have PLUS door panels before the converter and
VISTA PLUS monitors (without door panel) after the converter (see page
35).
Backbone encoder (Slave):
Activate this mode if you have PLUS door panels before the converter and
VISTA PLUS monitors and door panels after the converter. (See page 35).
Exchange interface:
Activate this mode if placing a PLUS porter's exchange in a VISTA PLUS
installation (see page 34).
D
e scription of the configuration jumpers.
JP1
Auto Off
JP2
On Off
JP4
On Off
* Factory default
Loads the VISTA PLUS installation with a
communications resistor.
Set to ON position only if you do not have
the VISTA PLUS door panel in the building
or backbone.
Set to ON to program the column.
This function should only be used if the module is being used as
backbone encoder (see page 35).
Once the programming progress is finished return the switch to
OFF position.
The programming steps are described on page 38.
End of line resistor (Only in porter´s exchange interface mode).
Set to AUTO if the porter's exchange is connected through a D4L-R5 or
D4L-R5R video distributor (recommended), if doing without this element,
set to the OFF position.
End of line resistor (Only in backbone encoder mode).
Set to Off in all converters except the last one (end of the coaxial cable).
To be handled exclusively by Golmar personnel.
Set always to Off.
37