golmar Vista Plus CD-PLUS/R5 Manuel D'installation page 34

INTRODUCTION
First of all we would like to thank and congratulate you for the purchase of this product manufactured by
Golmar.
The commitment to reach the satisfaction of our customers is stated through the ISO-9001 certification
and for the manufacturing of products like this one.
Its advanced technology and exacting quality control will do that customers and users enjoy with the
legion of features this system offers To obtain the maximum profit of these features and a properly wired
installation, we kindly recommend you to expend a few minutes of your time to read this manual.
INDEX
Introduction........................................................................................................................33
Index .................................................................................................................................33
Starting recommendations....................................................................................................33
Safety precautions ...............................................................................................................34
System characteristics ..........................................................................................................34
Operation modes ..........................................................................................................34-35
Description.........................................................................................................................36
Installation .........................................................................................................................36
Configuration dip switch.......................................................................................................37
Configuration jumper (End of line resistor) ..............................................................................37
Autodiagnostic Leds
P rogramming the converter
Installation diagrams ...............................................................................................................
Porter's exchange interface mode with D4L-R5 distributor .......................................................39
Porter's exchange interface mode with D4L-R5R distributor......................................................40
Backbone encoder mode (general door panels) ...............................................................41-42
Backbone encoder mode (coded panel) with D4L-R5 distributor ..............................................43
Backbone encoder mode (coded panel) with D4L-R5R distributor ............................................44
Troubleshooting hints......................................................................................................45-46
Compliance .......................................................................................................................47
STARTING RECOMMENDATIONS
O
The installation and handling of this equipment must be performed by authorised personnel
O
Install or modify the equipment without the power connected
O
Do not use excessive force when tightening the converter connection block screws
O
The entire installation must be at least 40 cm. away from any other installation.
O
Before connecting the system, check the connections between door panel, converter, distributor,
monitors, telephones and the power supply connection.
O
When starting the equipment for the first time, or after a modification, the system will remain inactive
for around 45 seconds due to the initial busy channel time
O
Do always follow the enclosed information.
.
.............................................................................................................38
(Backbone code) ..........................................................................38
.
.
33
.
.