Functional Description; Intended Use - BTI profiline WKS 230 E Notice Originale

page de 175

/ 175
Matières
Table des Matières
Signets

Table des Matières

Les langues disponibles

Do not restart the cutting operation in the

workpiece. Let the wheel reach full speed

and carefully reenter the cut. The wheel may

bind, walk up or kickback if the power tool is

restarted in the workpiece.

Support panels or any oversized workpiece

to minimize the risk of wheel pinching and

kickback. Large workpieces tend to sag under

their own weight. Supports must be placed under

the workpiece near the line of cut and near the

edge of the workpiece on both sides of the wheel.

Use extra caution when making a "pocket

cut" into existing walls or other blind areas.

The protruding wheel may cut gas or water pipes,

electrical wiring or objects that can cause kick-

back.

Safety warnings specific for sanding operations

Do not use excessively oversized sanding

disc paper. Follow manufacturers recom-

mendations, when selecting sanding paper.

Larger sanding paper extending beyond the sand-

ing pad presents a laceration hazard and may

cause snagging, tearing of the disc, or kickback.

Safety warnings specific for wire brushing oper-

ations

Be aware that wire bristles are thrown by the

brush even during ordinary operation. Do not

overstress the wires by applying excessive

load to the brush. The wire bristles can easily

penetrate light clothing and/or skin.

If the use of a guard is recommended for

wire brushing, do not allow any interference

of the wire wheel or brush with the guard.

Wire wheel or brush may expand in diameter due

to work load and centrifugal forces.

Additional safety warnings

Wear safety goggles.

Use suitable detectors to determine if utility

lines are hidden in the work area or call the

local utility company for assistance. Contact

with electric lines can lead to fire and electric

shock. Damaging a gas line can lead to explosion.

Penetrating a water line causes property damage

or may cause an electric shock.

When working stone, use dust extraction.

The vacuum cleaner must be approved for

the extraction of stone dust. Using this equip-

ment reduces dust-related hazards.

40 | English

Use a cutting guide when cutting stone. With-

out sideward guidance, the cutting disc can jam

and cause kickback.

When working with the machine, always

hold it firmly with both hands and provide for

a secure stance. The power tool is guided more

secure with both hands.

Secure the workpiece. A workpiece clamped

with clamping devices or in a vice is held more

secure than by hand.

Keep your workplace clean. Blends of materi-

als are particularly dangerous. Dust from light

alloys can burn or explode.

Never use the machine with a damaged

cable. Do not touch the damaged cable and

pull the mains plug when the cable is dam-

aged while working. Damaged cables increase

the risk of an electric shock.

Products sold in GB only: Your product is fitted

with an BS 1363/A approved electric plug with inter-

nal fuse (ASTA approved to BS 1362).

If the plug is not suitable for your socket outlets, it

should be cut off and an appropriate plug fitted in its

place by an authorised customer service agent. The

replacement plug should have the same fuse rating as

the original plug.

The severed plug must be disposed of to avoid a pos-

sible shock hazard and should never be inserted into

a mains socket elsewhere.

Products sold in AUS and NZ only: Use a residual

current device (RCD) with a rated residual current of

30 mA or less.