Memory Full; Error Messages /Malfunctions - vivocare Handy Mode D'emploi

5.7. Memory full

Pay attention that the maximum memory capacity is not
exceeded. When the memory is full, the old values are au-
tomatically Overwritten with new ones. When memory is
full, the display shown 1 second as follows to remind you
"memory full".
5.8. Memory– cancellation of all measurements Attention!
Before you delete all readings stored in the memory, make
sure you will not need refer to the readings at a later date.
Keeping a written record is prudent and may provide addi-
tional information for your doctor's visit. In order to delete all
stored readings, depress the MEMORY button for at least 5
seconds, the display will show the symbol «CL» and then
release the button to permanently clear the memory. Press
the MEMORY button while «CL» is flashing.

6.Error messages /malfunctions

If an error occurs during a measurement, the measurement is discontinued and
a corresponding error code is displayed.
Error No. Possible cause(s)
ERR 1 No pulse has been detected.
ERR 2 Unnatural pressure impulses influence the measurement result.
Reason: The hand was moved during the Measurement (Arte-
fact).
ERR 3
The inflation of the cuff takes too long. The cuff is not correctly
seated.
ERR 5 The measured readings indicated an unacceptable difference
between systolic and diastolic pressures. Take another reading
following directions carefully. Contact you doctor if you contin-
ue to get unusual readings.
27