Autodiagnostic Leds; Rogramming The Converter (Backbone Code) - golmar CD-V2PLUS/TP Manuel D'installation

38
If the short circuit is eliminated before 2
*
minutes (approx.), the converter will
automatically reset. Past this time it will
be necessary to reset the converter
using dip switch No. 3 (see page 37).
P
rogramming the converter.
The converter must be programmed with a backbone code (see page 35), which must be different for
each converter, following the steps set out below.
1 0 0
If there are more converters, repeat the previous steps introducing a different backbone code for
each of them.
If during one of these processes the red LED on the converter switches on, restart programming from
the beginning.
The autodiagnostic LEDs are placed next to the
configuration dip switch .
Green Led
Fixed: Correct operation.
Slow blinking: Programming active (SW1-1 to ON).
Quick blinking: Programming finished.
Red Led
Fixed: Programming error.
Blinking: There is a short circuit in the installation*
Activate the converter programming by setting dip switch
number 1 to ON.
The door panel will emit a tone and the green LED on the
converter will begin to blink slowly, indicating that
programming has begun .
0
Introduce the backbone code to program, followed by three
O.K.
zeros, then press the bell button.
To indicate that the equipment has been correctly programmed,
the door panel will emit a tone and the green LED on the
converter will begin to quick blinking.
Exit programming by setting dip switch number 1 to OFF and
pressing the C

AUTODIAGNOSTIC LEDS

D
escription of autodiagnostic LEDs.
between the bus wires.
PROGRAMMING
To access the door panel programming mode, press
the key button followed by the secret nstaller code
(factory default 1315), just as indicated in the door
panel manual .
"Cancel" button on the door panel
i
.