Description; Installation - golmar CD-V2PLUS/TP Manuel D'installation

36
D
escription of the converter.
D
etail of the converter installation.
Install the converter in a dry and protected place free from the risk of drip or water projections.
To avoid damage the converter must be firmly fixed.
3,5 x 50
DIN-7971
The converter can be installed on a DIN guide
(6 elements), pressing it lightly.
To extract the converter from the DIN guide,
use a plain screwdriver to lever the flange as
shown in the picture .
Install or modify the equipment without the power
connected.
3,5 x 50
The installation and handling of this equipment must be
DIN-7971
performed
To install the converter directly on the wall, drill two holes of
Ø6mm. and insert the wallplugs. Fix the converter with
the specified screws.

DESCRIPTION

DIN rail latch release
Autodiagnostic LEDs
Configuration dip switch
V2Plus Bus connection block
Label
End of line configuration jumper
Plus Bus connection block (TP video)

INSTALLATION

by authorised personnel
DIN 46277
.