Safety Precautions; System Characteristics; Operation Modes - golmar CD-V2PLUS/TP Manuel D'installation

34
O Install or modify the equipment without the power connected.
O The installation and handling of these equipments must be performed by authorised personnel.
O The entire installation must be at least 40 cm. away from any other installation.
O Do not use excessive force when tightening the connector screws.
O Install the unit in a dry and protected place without risk of drip or water projections.
O Avoid to place it near to heating sources, dusty locations or humid enviroments.
O Do not block ventilation holes of the unit so that air can circulate freely.
O To avoid damage, the converter has to be firmly fixed.
O
Protocol converter for the
Ü Permits the installation of Plus general door panels with the
Ü Permits the installation of a Plus coded door panel with
O
Up to 250 converters per installation.
O
Up to 32 apartments and 32 elements (monitors, telephones or call repeaters) per backbone.
O Up to 120 elements
backbone with 4 risers (being necessary the use of multiplexer MC-V2Plus).
O Up to 480 elements
backbone with 16 risers (being necessary the use of multiplexers MC-V2Plus connected in daisy chain)
or 250 apartments with coded panel (it also needs CD-V2PLUS/TP converter).
O
Simple configuration through easy access dip switches.
O
Autodiagnostic LEDS that allow detecting installation and/or programming errors.
O
Connection block for the Plus system with 4+TP installation.
O
Transceiver module EL564 to convert the coaxial connection to twisted pair.
O
A multiplexer is required to place the
O
The V2Plus door panel must have the microprocessor circuit EL500/V2Plus installed, with version 2.00
or later, for its compatibility with the protocol converter and the MC-
O
Permits the installation of a porter's exchange only on the side of the installation with the Plus system.
O
Maximum distance between the power supply and converter: 50m, with a wire section of 1.5mm.
O
Use Golmar RAP-2150 cable in the V2Plus system.
Transceiver module for video signal.
The transceiver module for video signal EL-564 converts the
coaxial to twisted pair and vice versa. This module is necessary in
a V2Plus system with a Plus coded panel or Plus general door
panels with a 3+Coax installation and convert the coaxial to
twisted pair, and therefore connect the video signal in the CD-
V2Plus/TP protocol converter of the entrance twisted pair.
Installation diagram on pages 45-46.
V2Plus system which permits the following functions:
(monitors, telephones or call repeaters) and 120
(monitors, telephones or call repeaters) and 120
V2Plus door panel between the converter and the monitors/telephones.

SAFETY PRECAUTIONS

SYSTEM CHARACTERISTICS

V2Plus
V2Plus monitors.
V2Plus

OPERATION MODES

Platea V2Plus Monitors
CD-V2PLUS/TP
Porter's
exchange
3 + Coax
Central de conserjería
Porter's exchange
1 1 2 2 3 3
4 4 5 5 6 6
o.k. o.k.
7 7 8 8 9 9
C C 0 0
ancel ancel
2
Lock release
system.
apartments per installation or
apartments per installation or
multiplexer.
2 2
2 2
2
FA-V2PLUS
M 2
4 + TP
EL-564
3 + Coax
Plus coded door panel
M
FA-PLUS/C
1 2 3 4
5 6 7 8
9 0 C
2
2
Continue